Yarn: Handspun Singles from Spritely Goods handblended batts in Arizona Sycamore colorway, combined with additional fiber that was blended by hand rather than by the carder.
Needles: US 6
Comments: Have I said recently how much I love lace? It's challenging to knit, and it has different "faces" to it at different stages of the process. Witness above and below - the moth, prior to blocking - it has such texture to it in its unblocked state!
I love these bumps - they were formed on the backside of the shawl, in the fircone lace section - witness the fuzzy halo from the angora :)
The patten itself is well written, though due to my own peculiarities with how I use markers I had a little bit of a challenge figuring out just what I was supposed to be doing during the transition rows, but if you follow the instructions, you should be fine.
Blocking this baby wasn't too bad, and it didn't seem to take any longer than my other shawls - I ran blocking wires across the top edge, stretched her tight evenly across the top (7-foot 8-inch wingspan on this one - I'm rather aggressive with my blocking though), then pulled the midline tight and pinned it in place (46 inches tall if I remember the measurement correctly). From there, it was a question of pinning out the coronas - I did this the same way I did the points on my other shawls - I pinned the "center" point of the "center" corona out on both left and right sides, then I did the next midpoints between those coronas and the bottom point and top points, and continued in this manner until each midpoint of each corona was pinned out - then I went back through and pinned out each of the loops in the corona to get that nice scallopy edge. I will admit to getting a bit impatient at that point, and pinning away at will from left to right along each corona, which has resulted in some slightly lopsided scallops, but I figure it will do for now ;) I'll have to reblock her sometime in the future anyhow :D
Those that followed along on my regular blog might recall that the yarn spun for this project was prepared in 2 different methods. The main fircone portion (the portion in the lower right in the above photo) was spun from blended batts. The yarn used in the outer portion of the shawl was prepared by actually blending fibers at the wheel - resulting in considerably more striping. The fibers used in the preparation were the same as those used in the batts, and also in the same ratios - they just spin up differently depending on how thoroughly blended they are.
The Moth was a pleasure to knit, I just regret that I can't seem to capture the slight sparkle that is present in the yarn - The colors remind me of a Sphinx Moth, though up close, there is more earthy green visible. I'm looking forward to the weather cooling down so I can actually wear the Moth rather than simply gaze at it!